Products & Services » Rust Proofing » Heavy Duty Spec 2

Heavy Duty Spec 2  - Off Road Rustproofing

(Order Code:- BS2)

Beam Heavy Duty Spec 2 corrosion protection is ideal for off road and four wheel drive ( 4WD ) vehicles, providing extra protection above and beyond Spec 1 and Australian Standard AS2662.2. The application is thicker and is applied more extensively than the Spec 1 to ensure that you are protected against harsh conditions that can penetrate deep into the panels of your car, like the red dust of the North West and salt from visits to the beach.

Below is a guide to a typical Application. ( Note: This may vary depending upon vehicle type ) 

Application Guide:

Beam ML602 is a highly advanced heavy duty corrosion inhibitive wax which is applied to:
  • Inside Door cavities, Pillars, Rocker Panels and Box Sections.
  • Behind headlight and grille areas
  • Inside Bonnet & Boot lid stiffeners and tailgate areas.
  • Inside Chassis rails
  • Inside Plenum Chamber.
Beam UB302B is a bituminous black underbody rust preventative which is spray applied to:
  • The complete under body and chassis.
  • Lower cavities of the front and rear guards.
  • Wheel arches, fuel, air and hydraulic tanks
  • Engine sump, transfer casing, drive line,axles and differentials.
  • Suspension components, brake housings and steering arms.
  • Fixing points for tow bars, bull bars and side steps.
Ultratect “DURON" is a 2K Teflon/Polyurethane Chemical & Corrosion Resistant dry film Clearcoat which is spray applied to:
  • Underside of bonnet
  • Painted areas of the engine compartment.


Options and related Treaments 

  • CATIII Electronic Anti-Corrosion System - For a complete anti-corrosion solution you should consider the advantages of installing a CAT System. Electronic Anti-Rust Systems can protect all those areas of your vehicle that cannot or shouldnt be sprayed with chemical rustproofing. In some cases The CAT system may be all that is needed to protect your vehicle from rust - Please enquire.  
  • Underbody or Upperbody only treaments may be more suitable in some situations - please enquire.
  • Rhino Lining - Polyurethane spray-on tray and surface coating - Ideal for inside load areas and to encapsulate and permanently protect high impact areas such as bull bars, side steps, internal floor pans, mudguards, wheel arches, chassis rails and most underbody components. Rhino Lining can be sprayed to any thicknessis, is slip resistant, prevents Rust and Corrosion, is Waterproof and chemical resistant and will not be damaged by flying debris or rocks - please enquire about how our Rhino Lining product can protect your vehicle. 


Application Time : (2 DAYS)

(Note: The above specification was last revised 1/3/2011 and should be used as a guide only. Some procedures may be altered or omitted for specific vehicle types or due to special customer requests. Beam reserves the right to alter this specification at any time without notice if new products or techniques become available.)

Australian owned and operated for over 80 Years Site Map | Privacy Statement | Quality Statement
Our Partners
Rhino Lining, Ute Tray MTA Defense Pak Ming Motor One VPS