RX200 Details Application Guide RX200 FAQ RX200 Brochure


APPLICATION GUIDE
 

SHAKE WELL BEFORE USE

RustStop RX200 is a transparent, flexible, long lasting rust and corrosion protection coating for metal surfaces, bare or painted and is even effective on rusted metal, as it penetrates and seals off the rust. It is ideal for any metal exposed to highly corrosive conditions.

RX200 is not intended for use as a final exterior vehicle paint finish.

  • Surface preparation: Can be applied to any metal surface, even with existing rust however flaking paint and/or loose rust needs to be removed to ensure maximum penetration. Product works best on matte surfaces. If used on polished or smooth surfaces, a light scouring is recommended to ensure better adhesion. Clean surface with RustStop PrepX or compatible cleaning solvent to remove grease, oil, dirt, etc. Ensure surface is completely dry. Mask or cover adjacent areas to protect from overspray.
  • Operating temperatures: Ideal application temperature between 15°C to 50°C.
  • Application: Apply using a standard paint spray gun (recommended), paintbrush or enamel roller. Apply successive, thin coats allowing each layer to dry between coats. Applying RX200 too thick will cause a wrinkled finish. Apply subsequent coats once touch dry (approximately 4 hours). Apply 1 to 3 coats according to environmental exposure and conditions. 3 coats is only recommended for highly extreme conditions. Avoid drips, runs and a wrinkled finish by applying successive very thin coats.
  • Drying and curing time: Allow 4 hours between coats or until touch dry. RX200 can take up to 24 hours to fully cure ensuring proper surface bonding and ongoing flexibility. These times are typical for temperatures between 15°C to 30°C at 50% humidity. Colder temperatures and higher humidity will result in longer drying and curing times.
  • Clean up: Use mineral spirits to clean tools. Wash hands thoroughly with soap and water after use.
  • Coverage: Due to the fact that the first coat penetrates deep into the metallic substrate and existing rust, more product is used, and considerably less will be used for subsequent layers. First coat coverage will be about 8m2 to 10m2 per litre. Coverage for subsequent coats will be between 10m2 and 14m2 per litre.
  • Helpful tips: It is extremely important to apply successive very thin coats, rather than one thick coat, to avoid wrinkling. A thin coat will cure quicker and will result in a stronger layer. More product does not mean more protection.
  • Storage: Store container in cool, well-­‐ventilated area out of direct sunlight. Store above -­‐ 15°C. Ensure container is kept air-­‐tight to prevent evaporation. During use, remove product to be used from container and replace the lid.
RX200 Details Application Guide RX200 FAQ RX200 Brochure
Australian owned and operated for over 80 Years Site Map | Privacy Statement | Quality Statement
Our Partners
Rhino Lining, Ute Tray MTA Defense Pak Ming Motor One VPS