Products & Services » Rust Proofing » Surface Spec 3

Surface Mining Spec 3 - Industry Minimum Standard

(Order Code:  BS3) 

Beam Surface Mining Spec 3 is a heavy duty application of bitumen, wax and dry film products specifically designed to ensure the protection of industrial vehicles against environmental conditions typically encountered in the mining and resource sector.

Below is a guide to a typical Application. ( Note: This may vary depending upon vehicle type )


Application Guide:

Beam ML602 is a highly advanced heavy duty corrosion inhibitive wax which is applied to:
  • Inside Door cavities, Pillars, Rocker Panels and Box Sections.
  • Behind headlight and grille areas
  • Inside Bonnet & Boot lid stiffeners and tailgate areas.
  • Inside Chassis rails
  • Inside Plenum Chamber.
Beam UB302B is a bituminous black underbody rust preventative which is spray applied to:
  • The complete under body and chassis.
  • Lower cavities of the front and rear guards.
  • Wheel arches, fuel, air and hydraulic tanks
  • Engine sump, transfer casing, drive line,axles and differentials.
  • Suspension components, brake housings and steering arms.
  • Fixing points for tow bars, bull bars and side steps.
  • Internal Foot wells and floor.
Ultratect “DURON" is a 2K Teflon/Polyurethane Chemical & Corrosion Resistant dry film Clearcoat which is spray applied to:
  • Underside of bonnet
  • Painted areas of the engine compartment.
  • Alloy engine components.

Options and related Treaments
  • CATIII Electronic Anti-Corrosion System - For a complete anti-corrosion solution you should consider the advantages of installing a CAT System. Electronic Anti-Rust Systems can protect all those areas of your vehicle that cannot or shouldnt be sprayed with chemical rustproofing - Please enquire.  
  • Underbody or Upperbody only treaments may be more suitable in some situations - please enquire. 
  • Ultratect “BEAMASTIC" is a High Build 2K epoxy mastic for coating chassis and under body areas. Beam highly recommends this coating as an upgrade replacement for the traditional Bituminous Based under body coating used in this specification. See Ultratect Surface Mining Spec 7
  • Some or all of the exterior painted surfaces can be coated with our  Ultratect "DURON" 2K Teflon/Polyurethane Clearcoat to provide long-term protection against attack by water, acids and most chemicals. This product is ideal for Roofs, Gutters, doors, Bonnets, Side steps, Bull bars in fact its applications are almost unlimited. Ultratect "DURON" is UV stable (will not go yellow) and will not significantly change the appearance of the substrate. It can also be removed or repaired easily at any time if required.
  • Rhino Lining - Polyurethane spray-on tray and surface coating - Ideal for inside load areas and to encapsulate and permanently protect high impact areas such as bull bars, side steps, internal floor pans, mudguards, wheel arches, chassis rails and most underbody components. Rhino Lining can be sprayed to any thicknessis, is slip resistant, prevents Rust and Corrosion, is Waterproof and chemical resistant and will not be damaged by flying debris or rocks - please enquire about how our Rhino Lining product can protect your vehicle. 

Application Time : (2 DAYS)

(Note: The above specification was last revised 7/7/2012 and should be used as a guide only. Some procedures may be altered or omitted for specific vehicle types or due to special customer requests. Beam reserves the right to alter this specification at any time without notice if new products or techniques become available.)

Australian owned and operated for over 80 Years Site Map | Privacy Statement | Quality Statement
Our Partners
Rhino Lining, Ute Tray MTA Defense Pak Ming Motor One VPS